Hi I have the KDL-LCD1260 I need to adjust the 4 screws on the buildplate, I believe it is a hex security key, can someone help in were to buy one, my prints work about 50% most of the time one side of the build plate sticks and the other side ands up sticking to the FEP film thanks Dale
Hi Dale007, this is an issue with the springs. No matter how much you adjust you will still have the same problem. When you take apart the 4 screws to separate the buidplate from its holder, you will notice that there are 4 springs. As you are having the problem you mentioned, you will notice that some of the springs have smaller diameter. All should be fitting tight in the hole. If they are loose then you have to change them. You must contact your seller and request a dozen of those springs, you might get few good ones. Your problem will be solved.