I have a question about the configuration


#1

I have a question when I set up a resin.

I think I understand that when you adjust the dimensions of the table (according to this screen)

you then have to change the density of the pixels.

Is it necessary to do all this every time different resins are used?

thank you very much


#2

Pixel density is a function(OutputResolution/BuildSize) of the screen hardware and the software configured resolution. It is not a function of the resin. So the answer your answer is No, you should not have to change it.

So, once you do the math(OutputResolution/BuildSize) or the calibrate for a certain printer configuration here:


You shouldn’t have to do it again for that printer configuration.