Gcode for lift


#1

Hi,
sometimes the prints does’t attach to the build plate, and when it happens, i can check only the print only at the end.
Is it possible to insert a GCODE that after 10 or more layers raises the build plate of 5 cm and then continue to print?

i think that it is a good solution to check the print.

Thank you


#2

Sure, you can do that and much much more. Check out this page for examples:
https://wiki.photonic3d.com/doku.php?id=gcode_examples

And check out this for variables you can use in the gcode:
https://wiki.photonic3d.com/doku.php?id=gcode_templates